GET /radar/attacks/layer3/timeseries

Measurement units, eg. bytes.

Possible values:

• "BYTES"
• "BYTES_OLD"

Default value: "bytes"

End of the date range (inclusive).

Filters results by IP version (Ipv4 vs. IPv6).

Filters results by location. Specify a comma-separated list of alpha-2 codes. Prefix with - to exclude locations from results. For example, -US,PT excludes results from the US, but includes results from PT.

Filters the results by layer 3/4 protocol.

Start of the date range.

Aggregation interval of the results (e.g., in 15 minutes or 1 hour intervals). Refer to Aggregation intervals.

Possible values:

• "1h"
• "1w"
• "15m"
• "1d"

Filters results by date range. For example, use 7d and 7dcontrol to compare this week with the previous week. Use this parameter or set specific start and end dates (dateStart and dateEnd parameters).

Filters results by Autonomous System. Specify one or more Autonomous System Numbers (ASNs) as a comma-separated list. Prefix with - to exclude ASNs from results. For example, -174, 3356 excludes results from AS174, but includes results from AS3356.

Array of names used to label the series in the response.

Format in which results will be returned.

Possible values:

• "CSV"
• "JSON"

Specifies whether the location filter applies to the source or target location.

Possible values:

• "TARGET"
• "ORIGIN"

Default value: "ORIGIN"

Normalization method applied to the results. Refer to Normalization methods.

Possible values:

• "PERCENTAGE_CHANGE"
• "MIN0_MAX"

Filters results by continent. Specify a comma-separated list of alpha-2 codes. Prefix with - to exclude continents from results. For example, -EU,NA excludes results from EU, but includes results from NA.